A Duraskirt is a concrete panel skirting system that is typically sold in mobile home skirting kits for people to install them in their homes. This is something easy that you can install on your own without seeking the advice of the services of a professional. There are some tools that you need to have for you to install them successfully. These necessary tools include diamond saw blade and saw, caulk gun, taper measure for measuring purposes, straight edge, and finally a pencil for marking points. If you are not aware of the DIY installation procedure, don’t worry since it is not something complex for you, and through this guide is where you are going to gain everything that you may need. Therefore, here is a step by step guide you need to know about installing mobile Duraskirt in your home.
To begin, make the cement board well, and this is done by placing a panel on each side of the underfloor foundational with a typical width then you will have to use the pencil to give necessary markings that may have to assist you in remembering the points for accuracy. You need to pay attention to this process not to make any mistake in terms of the cuttings for you to make sure the skirtings fit perfectly to the places where you need to fix them. Then, you need to lay down the two Duraskirt panels together, and here you need to check and make sure their backs are together with the white marks being side by the side of each other.
The next step is labeling the market, and this is where you will have to use the pencil well since it is the only perfect tool for marking of the points. The marks should represent the height and width of reasonable lengths. You need to give the top a two inches space in the markings since it will be beneficial for the total fit to make sure you do a commendable job. When marking with a pencil, you need to make sure the marks are well seen for you to avoid confusion that may be caused hence doing the entire work to flow badly. A pencil will have to give a black mark, and you also need to make distinct marks for you to avoid confusion.
The final step is when you are required to cut the two sides of the well keenly, and this is to make sure you are leaving at the bottom of the edge the fabric well positioned. Since there is nothing hard in this process and that its why the DIY approach is recommended and the only thing required of you is to be keen with the work, and you will have commendable results that will have to make you happy. You may also decide to set and label all pieces inwards and ensure that you are using a good frame that is going to hold them well.
Since everything is now set for you, you need to make sure you are leaving a gap between the top of the frame and the bottom of the sliding. Therefore, with this guide, you are going to find it easy to install the Duraskirt effectively.